HOW TO ADD NEWS SERVICES TO YOUR AXESS STORY PAGER

Use this procedure if you would like your pager to receive free news, sports, weather, stock market, or entertainment updates

Button Function During Programming

Right Key: Used to confirm and complete each step of programming.

Middle Key: Used to move the cursor and change screens.

Left Key: Used to change the value of the flashing digit.

Before entering the programming mode, you will need to set the date and time exactly as follows:

Date: 08/01/2020

Time: 8:30 AM

Be sure to begin the next step quickly to insure that the time does not change.

Entering Programming Mode

Remove the battery and re-install the battery while holding the left and center buttons simultaneously. Continue holding these buttons until “Set Cap 1” appears on the display. If the capcode appears instead, then the date was set incorrectly, or too much time elapsed and the date changed. You will need to reset the time as shown above.

Programming Procedure

1) Press the center button twice and Set Cap 3 will appear on the display, then press the right button. IMPORTANT: You can enter news service capcodes in any order you like, but news service capcodes must start in capcode slot 3 and they must run consecutively. For example if you set all news service capcodes into your pager you will put them in capcode slots 3,4,5,6 & 7. Do not change capcode 1, capcode 2, or make changes to any other settings.

2) Determine the frequency of the pager and use the capcode lists below as your guide. Set the capcodes based on the pager’s frequency. If the pager has a white square label with a four-digit number, that is the frequency. If there is no white label check the bottom number on the right side of the back label. If it starts with 16..... the frequency is 6625, if it starts with 17..... the frequency is 6125.

Frequency 6625

0001300007 (All services)

0001300023 (All services)

Frequency 6125

0002009091 (News)

0002009092 (Sports)

0002009093 (Business / Stock Market)

0002009094 (Weather)

0002009096 (Entertainment)

3) The leftmost digit will be flashing, this is the cursor. Use the center button to move the cursor to the digit you need to change. Use the left button to change the value of the digit. Continue this process until you have set the entire capcode. Then press the right button to complete the process and return to the menu.

4) Press the center button one time to go to the next capcode slot and press the right button to allow programming of this capcode.

5) After you have entered the last capcode you want to change and have returned to the menu, (The screen should read “Set Cap 7” for example) keep pressing the center button through all of the remaining capcode screens. Keep pressing the center button to bypass Collapse, Set Option, Msg Capacity, Set Language & Initial, until Escape is displayed. Press the right button to save the changes.